Knowledge Base - FAQ

Certifier 40G Selected the wrong limit (re-certification)

Tuesday, December 31, 2019
Submitted by ryan.grace on October 23, 2021 - 2:42pm
Question: 
My cable tests, with my Viavi 40G Certifier, were tested with the wrong limit selected. Is there a way this can be changed after the fact or do I have to retest the cables over again?
Answer: 
For cat 6A and below the 40G Certifier always tests and saves data out to 500mhz (Cat6A) so the cables can be re-certified to a different limit using the J-Reporter software. With the results open in J-Reporter, select the cable/cables to be changed by highlighting them and then right click and select Re-certification. You will get a pop up window of limits to chose from. Pick the correct limit and hit OK. The software will apply that limit to those selected cables. 

Product Family:

Support at Every Step

We provide support, services, comprehensive training and the resources you need. It’s all part of what we do to maximize the value of your VIAVI investment.

Value add services that compliment your VIAVI system solution and instrument portfolio to provide a total cost of ownership

Customer Service that provides Return Material Authorization (RMA) for repair and calibration

Technical education solutions, product training, and blended learning for technicians who are using new products or working with existing tools

Technical Assistance Center to assist you in using/configuring products or address issues regarding product performance