STC: How to create a B2B Unicast VxLAN configuration on VIAVI TestCenter Application.

STC: How to create a B2B Unicast VxLAN configuration on VIAVI TestCenter Application.

• Open VIAVI TestCenter Application, connect to a chassis, and reserve 2 ports.  (The ports must be connected Back-to-Back). • On the top menu, go to Wizards > Wizards… • Type VxLAN at the Filter textbox and select the VXLAN option under Switching. • On the Configure VXLAN Ports screen, select both ports. • Set the IP addresses and gateways as in a Back-to-Back scenario. • On the Configure Learning Mode, select Unicast. • You can leave the values in the other screens as they are. • On the Configure Non-VXLAN Port screen, un-check the Use Non-VXLAN Ports, and hit the Finish button. • Go to the All Stream Blocks at the left menu, and hit the Add… button. • Enable both ports, and create a Bidirectional stream from the VM emulated device under port 1 to the VM emulated devices under port 2. • Don’t forget to click the Add button. • You can leave the default values on the other screens. • Apply the configuration in the VIAVI TestCenter Application, and start the devices. • Go to the VxLAN tab, and wait until the VTEP state changes to STARTED. • Right-click on any VTEP device and go to VXLAN > Show VXLAN Bindings. • If the configuration is correct, you will see: • The number of how many Bindings have STC learned and the number of VM MAC addresses resolved. • All the bindings states as Resolved.  NOTE: Please consider that you need to do this for both ports.