VIAVI TestCenter: Does the Lab Server require both the Admin port and TestBed port to have its IP addresses configured?

VIAVI TestCenter: Does the Lab Server require both the Admin port and TestBed port to have its IP addresses configured?

• The Admin port is required but not the TestBed port. • Only if the topology as indicate in the Lab Server install documents was used, then it would need the TestBed port configured. Some Q & A below: • According to the GETTING STARTED document I need to configure a VM and a Hypervisor server address. • • Can someone provide more information why this is required in addition to ADMIN and TESTBED port? • • Should I be able to connect via telnet to the labserver? • • Should the Bare metal/Hypervisor server network address be the same as the ADMIN (management port) address? •