VIAVI TestCenter - What are the corrected issues for the 5.10 release.

VIAVI TestCenter - What are the corrected issues for the 5.10 release.

                                                                                                          Back to VIAVI TestCenter - What are the corrected issues per release? (Index)   CR: Case NumberCR Created DateCR: Engineering ProjectSubject13895257/1/2019MX3/FX3-100G-Tx25G / LAG mode - Link keeps flapping after pulling out / re-inserting optical fiber.13955757/29/2019TSNAuto - IEEE802.1AS Pdelay turnaround time issue.141064610/22/2019PX3-100G-T1210G mode - Flooding the DUT with local/remote fault alarm messages after shutdown interface on DUT side.141550511/18/2019Routing ServicesSTC 4.88 routing config loaded to 4.95 caused Assertion Failed error.14238541/21/2020PGA Base BPK1001AWhen there are no devices configured to join the 11 MC groups, RxStreamSummaryResults are not counted for the SBs on port1.14272552/4/2020TSNSync error message when enabling sync on 5 or more ports "Unable to add SyncEthPortConfig 13 to Port //4/1 due to max relation constraint limit : 1".14276582/7/2020SPT-C50-AT-3Issues with ppm adjustment of NIC-43 on SPT-C50.14316202/20/2020Routing ServicesLDP flapping in v5.05 when we use global device start option.14328642/24/2020Firmware InfrastructureRx counter is showing 0 when sending ICMPv6 packets in raw stream.14417444/30/2020Routing ServicesVIAVI GUI is crashing when changing some parameters under OSPF.14350393/9/2020MX3/FX3-100G-TxSTC 100G link ERROR between FX3-100GTN-T2 and DUT when using Cisco LR4-S optics, B2B on both works fine.14367943/23/2020DX3-100G-T1210G / 25G modes - Generated PRBS errors are seen in "Basic Traffic Results / Errors", but not in "Detailed Stream Results/ Errors".14376083/31/2020DX3/PX3-400G-T2400G mode - STC GUI emits this error when clearing the capture Pattern Filter: Capture_2.SetCapturePatternAndExp code -10002 faultMsg Stored config has invalid/unknown data.14381414/2/2020Routing ServicesSTC: GUI crash with 100 Hub&Spoke LSP for ISIS.14387234/6/2020PX3-100G-T12ARP is failing to resolve Endpoint MAC Address and sending traffic to the gateway mac address.14389124/8/2020Metro Ethernet"License for EOAM is either invalid or couldn't be found" when applied with only BPK-1059A.14396514/15/2020Data Center256 VTEPs – 256 VNI – 1VM per VNI = GUI hanged.14397434/15/2020C50-KIT-11AX-x / MX2-11AX-xChanging the WiFi PHY Characteristics needs a module reboot in order to get consistent results.14397794/16/2020TestCenter IQSTC 5.08 - TestCenter IQ doesn't provide charts if the traffic source port is a WIFI port.14398784/16/2020DX3-100G-T1210G / 25G mode - After user resets DUT port, Rx Frame, RX bits & RX Rate counters report incorrect values.14422095/4/2020C50-KIT-11AX-x / MX2-11AX-xSTC 5.09 - 802.11r FT Roaming - roam order does not follow the target BSSIDs as configured14429935/11/2020Enhanced L4-7 EL4-7 is not working on Wifi ports.14436095/14/2020Enhanced L4-7 EL4-7 TCP Latency is NOT present and Results are blank.14436415/14/2020Enhanced L4-7 EL4-7 all kBps & Bps Rate counter labels need to be changed to kbps & bps, as these are bits per second, not bytes per second.14391444/9/2020HLTAPINeed support for mixed messaging mode for PTP feature in HLTAPI.14394844/13/2020HLTAPIv5.08 HLTAPI Not backward compatible with 5.01 STC-API.14396214/14/2020HLTAPIHLTAPI needs to be able to unset ControlFlag in BGP "bgpipv4vplsconfig" as well as create IPv4-VPLS-BGP routes.14397684/15/2020HLTAPIHLTAPI emulation_igmp_control needs to support Rejoin14399024/16/2020HLTAPIThe src mac, src IPv4, dst IPv4 addresses are getting modified when trying to modify the vlan in streamblock.14374143/28/2020HLTAPIDuring traffic_config, modify call changes the l2encap and deletes the VLAN header.14396764/15/2020AccessIPoE and PPPoE user could not offline issue.14406964/22/2020Routing ServicesGUI complaining about LspPing license not found, even when permanent LSP Ping license has been installed.14365783/20/2020HLTAPIIn the “interface_config” function, both the “netmask” and the “enable_ping_response” arguments are being ignored14418975/1/2020TestCenter IQEnhanced L47 Client Aggregation Stat is using the wrong label