CyberFlood: How to log in using "ssh admin" for the first time after a new installation
Knowledge Base - Solution
Starting with the Environments/Versions listed below, your admin password will be uniquely assigned. This assignment is based on the MAC address of the management interface as defined in your VM network configuration.
NOTE: This procedure does not apply when you are upgrading controller software. (Your password is maintained across upgrades.) This procedure applies only for brand new installations.
To set up your admin password:
Enter the following:
ssh admin@IP addr>
password: MAC address without colons or delimiters>
“Welcome” screen appears and prompts you to change the password for admin.
IMPORTANT: Remember this new password, as there is no “reset” or recovery method.